F3 Field Service Manual – Level 1 Maintenance
Page 16
3.2.2. Handle Reassembly:
•
Position the right handle half onto the upper shaft.
•
Locate the main wiring loom into the correct slots in the right handle half.
Starting from the main body of the main wiring loom, lay the cable into the
cable channels. Ensure that main wiring loom plug exits the top of the
handle in front of the upper screw boss (see figure below). Ensure that the
lower portion of the wiring loom cable sits under the rear handle screw boss.
There should be no excess cable at the bottom of the handle. Excess cable
should be carefully pulled through from the rear of the upper shaft.
•
Ensure that the on/off switch slider is correctly positioned.
Figure 15 Right Handle Half showing loom in cable channel (yellow, blue), on/off
switch slider (red), upper screw boss (orange), and cable under screw boss (green)
•
Place the nut (which secures the speaker pod assembly to the handle) into
the recess near the top of the handle. Care must be taken to ensure that
this nut stays in place during the following steps.
Figure 16 Handle Nut position
•
Fit the earset dustcap into the recess in the handle just forward of the earset
socket.
Figure 17 Earset Dustcap position
•
Carefully fit the left handle half to the right handle half and upper shaft.
