F3 Field Service Manual – Level 1 Maintenance
Page 15
3.2. Handle
3.2.1. Handle Disassembly:
Note:
The noise cancel button and earset connector are an integral part of the main
wiring loom and this assembly is waterproof. Do not try to disassemble the
main wiring loom. It is not repairable.
•
Remove the speaker pod (Section 3.1.1 Speaker Pod Disassembly).
Figure 13 Handle Exploded View
8013-0001 HANDLE ASSEMBLY F3
1
4002-0039 NUT M4 HEX SS
2
3004-0016 RIGHT HANDLE HALF (part of HANDLE L+R KIT F3)
3
3004-0016 LEFT HANDLE HALF (part of HANDLE L+R KIT F3)
4
4002-0038 NUT STANDARD SS F3
5
4309-0037 DUSTCAP EARSET F3
6
8301-0031 SWITCH ASSY SLIDER F3
7
9511-0023 WIRING LOOM F3 SHAFT/HANDLE
8
4003-0082 BOLT M4X20 SKT SS
9
4003-0081 BOLT M4X10 SKT SS
Figure 14 Handle Parts List
•
Undo and remove the four bolts and nuts holding the handle halves together.
•
Carefully separate the left handle half from the upper shaft.
•
Remove the earset dustcap (5).
•
Remove the nut (4) that secures the lower speaker pod screw to the handle.
•
The main wiring loom (7) and on/off switch assy slider (6) can now be
removed from the right handle.
Note:
If the main wiring loom (7) needs to be replaced, carry out Section 3.4.1
Electronics Pack Removal. Then carefully pull the loom towards the front of
the detector until the loom comes out of the upper shaft. After replacing the
loom, refit the electronics pack (Section 3.4.4 Electronics Pack Refit) and
reassemble the Handle.
