F3 Field Service Manual – Level 1 Maintenance
Page 13
•
Remove the top half of the speaker pod – lift the pod gently upward and
disconnect the speaker pod plug from the main wiring loom. Support the
main wiring loom socket against the lower half of the speaker pod when
disconnecting the speaker pod plug.
Note:
Do not try and remove the loudspeaker, ground balance/audio reset button or
wiring from the upper half of the speaker pod, these components are
permanently sealed into the upper half of the speaker pod.
•
Remove the screw (4) which secures the lower half of the speaker pod to the
handle. (The nut for this screw sits in a recess between the two handle
halves).
P0713-A
Figure 9 Lower Speaker Pod showing screw securing Lower Speaker Pod to Handle
•
Remove the lower half of the speaker pod – lift the rear of the pod upwards
and remove the pod towards the front of the detector.
Note:
The speaker pods halves should always be kept attached to each other
during storage and transportation to ensure that the loudspeaker and ground
balance/audio reset button seals are not damaged.
3.1.2. Speaker Pod Reassembly:
•
Ensure that the handle has been fully assembled (Section 3.2.2 Handle
Reassembly).
•
Peel back the shroud at the end of the speaker pod plug.
Figure 10 Peel back the shroud at the end of the Speaker Pod Plug
