Minarik MMBOSS Series, User Manual

Page: 33 / 56

Automatic restart upon power restoration
After a one-second time delay, all drives automatically run to set
speed when power is applied and the ENABLE input is jumpered.
ENABLE/DISABLE switch
Install a single-pole, single- throw switch between the ENABLE
and COM terminals. Close the switch to disable the drive and
coast the motor to a stop. Leave open to enable the drive and run
the motor.
RUN/BRAKE switch
Install a single-pole, single-throw switch between the BRAKE
and COM terminals. Close the switch to brake the motor to a
stop. Open the switch to accelerate the motor to set speed.
Coast to a stop
To coast the motor to a stop, remove power to the drive. You
may also close the ENABLE/DISABLE switch to coast to a stop.
Decelerate to minimum speed
Install a single-pole, single-throw switch between the speed adjust
potentiometer wiper terminal and the drive W terminal
(Figure 9, page 26). The motor will coast to minimum speed
when the switch is opened. The motor will accelerate to set speed
when the switch is closed.
25
Operation
250-0288.qxd 6/9/00 1:05 PM Page 25