2-29
2
2
2
2
Chapter 2 Basic Operation
4
Remove the used media from the paper
tube on the feeding side.
5
Remove the roll shaft on the feeding side
and remove the paper pipe.
6
Set a new roll media on the roll shaft.
7
Set the roll shaft on the feeding side AMF.
8
Use safety pin to hold new media on used
media.
• In the case of full-width media, keep it even at
about 5 places.
9
Raise the clamp.
10
Switch the take-up side AMF to "manual"
and wind up the new media connected to
the used media.
11
When new media is wound up to the
winding roll shaft, change the switch on
the take-up side AMF to "AUTO" and stop
winding.
12
Close both right and left AMF covers on
the feeding side.
13
Remove the safety pin holding the media.
14
Keep the media tension evenly and lower
the clamp.
15
Remove the used roll media from the take-
up roll shaft and set the paper tube
removed from the feed roll shaft.
16
For the subsequent media setting
procedure, refer to the manual 2 and the
following "Set role media" manual 18.
(Tension bar position adjustment)
•
Adjust the position of the tension-bar
with the switches on the left of the feeding
device.
Resetting the proper temperature
Estimation of temperature setting
The color fixing temperature is based on 180 °C and should be adjusted according to the nature of the media to be used.
Other Settings
Reset timer for filter cleaning, filter
change
Filter cleaning alerts are displayed every 300 H, filter
exchange alerts are displayed every 2000 H.
Clean the filter or replace the filter, then reset the timer
with the following procedure.
1
Touch the
button on the top screen.
• The setting menu will be displayed.
• Do not close the cover of the feeding side AMF yet
at this point.
• Be careful not to wrinkle the joined media.
If wrinkles are contained in the media, there is a
possibility that safety pins and media get caught in
the color fixation device frontage and inside.
• During winding, check that the media does not get
caught on the upper part of the grid roller or the
upper part of the color fixation device.
Set higher temp
Set lower temp
Remarks
Color development
Uncolored (dull color)
Stain
Many stains
Media shrinkage
Shrinking is large
Depending on the media characteristics, media may shrink
by 2% when coloring.
Resolution (pass)
Low pass mode
High pass mode
When the high pass is set, the time in the furnace
becomes long, so set the set temperature low.
Media thickness
Thick media
Thin media
Please set the temperature high for thick (high density)
media.
