2-12
Chapter 2 Basic Operation
14
Go to the front of the machine, raise the
clamp lever while holding the edge of the
media in your hand, and pull out the
media.
• Make sure that there are no wrinkles at the front
or back of the machine.
15
Close the cover on the left of the feeding
device at the back of this machine.
• Close the covers and rock the cover.
• Lock the roll shaft rotation.
16
Go to the front of the machine, and lower
the clamp lever while stretching the media.
17
Adjust the position of the tension-bar with
the switches on the left of the feeding
device.
(1)
Set the rotation direction switch to the bottom
arrow.
(2)
While pulling the pin on the outside of the
tension-bar lock plate, set the left side switch
to [Manual].
(3)
The tension-bar lowers a little. Switch back
and forth between [Manual] and [Auto] until
the tension bar is almost parallel to the floor.
When the tension bar is almost parallel to the
floor, switch back to [Auto].
18
Confirm that the opening at the aperture
plate on the color fixation device is large
enough.
•
Make sure that the media is fed straight to the
brake roller.
• Exercise caution when setting the media on a hot
color fixation device, as its extremely high
temperature may cause you to sustain burns.
Opening at the
aperture plate
Aperture plate
Side view
Pulling roller
Opening at the
aperture plate
Front
Back
Pulling roller
