MIMAKI TS500-1800, Operation Manual

Page: 148 / 184

5-14
Message Cause Solution
An abnormality of the external heater
has been detected.
• Contact a distributor in your district, our
office or our call center.
• When you do not use the external heater,
set the external heater to “OFF” in the
“HEATER” of the Setting Mode (
P.3-3).
By doing this, you can perform printing.
The external heater is not connected
correctly.
• Check the connection between this
machine and the external heater.
• Even if you performed this, if the same error
is displayed, contact a distributor in your
district, our office or our call center.
• When you do not use the external heater,
set the external heater to “OFF” in the
“HEATER” of the Setting Mode (
P.3-3).
By doing this, you can perform printing.
The cover of the media take-up
machine was open was detected.
• Check the cover of the media take-up
machine. Even if you close the cover, if the
same error is displayed, contact a distribu-
tor in your district, our office or our call cen-
ter.
The control limit sensor of the media
take-up machine was detected.
• Lower the position of the tension bar at the
take-up side. Even if you lower the position,
if the same message is displayed, contact a
distributor in your district, our office or our
call center.
An abnormality occurred in the take-
up status of the media take-up
machine.
• Check that the media is set on the media
take-up machine correctly.
• Check that the paper core for taking up
media does not run idle.
The cover of the media feeding
machine was open was detected.
• Check the cover of the media feeding
machine. Even if you close the cover, if the
same error is displayed, contact a distribu-
tor in your district, our office or our call cen-
ter.
The control limit sensor of the media
feeding machine was detected.
• Lower the position of the tension bar at the
feeding side. Even if you lower the position,
if the same message is displayed, contact a
distributor in your district, our office or our
call center.
An abnormality occurred in the feed-
ing status of the media feeding
machine.
• Check that the media is set on the media
feeding machine correctly.
• Check that the paper core of roll media
does not run idle.
< L OC A L >
E . H E A T E R E RROR
< L OC A L >
E . H E A T E R CON N E C T
< L OC A L >
T a k e - U P C o v e r OP E N
< L OC A L >
T a k e - U P L i m i t D E T E C T
< L OC A L >
T a k e - U P WRONG
< L OC A L >
F e e d i n g C o v e r OP E N
< L OC A L >
F e e d i n g L i m i t D E T E C T
< L OC A L >
F e e d i n g WRONG