MIMAKI JV3-130SPII, Operation Manual

Page: 86 / 150

- 4.10 -
MEDIA SET P. A.7
This function sets the method of media detection.
SELECT :
During the initial operation, the device displays a menu for selection of “roll
media” or “cut sheet media”.
When “roll media” is selected, only the width of the media is detected. When
“cut sheet media” is selected, both the width and length of the media are de-
tected.
WIDTH :
Select this method when a roll media is used.
Only the width of a media will be detected.
When the media is set and the clam lever is pushed up, the device detects only
the media width automatically.
VACUUM P. A.7
Sets the absorbability of the media. If the media tends to stick to the platen, select
LOW.
(STANDARD, LOW, OFF)
MM / INCH P. A.7
Set a unit of set values displayed.
(MM, INCH)
STAMP P. A.7
Prints the date of output and plotting condition at end of plotting.
MODE STAMP :
Print the plotting condition. (ON, OFF)
TIME STAMP :
Print the date of output. (ON, OFF)
AUTO CLEANING P. A.7
The head is cleaned automatically.
Perform cleaning for each plot to prevent plotting failures.
(ON, OFF)
SETUP RESET P. A.7
This function resets the current plotting conditions to the factory-set plotting conditions.
Execute this function for each of the types of set plotting conditions.