MIMAKI DM2-1810, Operation Manual

Page: 103 / 146

- 6.5 -
Ink Limit
1 2 3 4 5 6 7 8 A B C D E F G H
Ink Color
1 2 3 4 5 6 7 8 A B C D E F G H
Ink Type
1 2 3 4 5 6 7 8 A B C D E F G H
Ink IC Error
1 2 3 4 5 6 7 8 A B C D E F G H
Ink Count Error
1 2 3 4 5 6 7 8 A B C D E F G H
Head Height
Check HeadHeight
Check Stop SW or
Station Cover
Blower Filter
Replace Filter
Service Call
001
Service Call
002
The ink cartridge will expire
soon or has expired.
Replace the ink cartridge is shown
on the LCD with a new one.
Check the number of the loaded
ink cartridge.
Warning message Cause Corrective measure
Problems where error messages are given on the LCD
TPig ERROR
1 2 3 4 5 6 7 8 A B C D E F G H
Please Capping
The Head
TPig ink has been set at the
front side of the carriage in the
initial setting of mixed inks.
Head stays uncapped for more
than 30 seconds.
Set the TPig ink at the back side of
the carriage.
Press the XY key or select [Sta-
tion]-[Carriage Out] to cap the
head. ( page 5.8)
(Using the TPig ink)
(Using the TPig ink)
(Using the TPig ink)
(Using the TPig ink)
The color of the loaded ink
cartridge is different from the
previous one.
The type of the loaded ink
cartridge is different from the
previous one.
The IC chip of the ink cartridge
cannot be read normally.
The loaded ink cartridge is
defective.
The head height is incorrect.
The station cover is open or the
stop switch is pressed.
It indicates when the filter at the
right/left absorption table must
be replaced.
Time to replace regularly
replaceable parts.
Attach the ink cartridge(s) corre-
sponding with the color shown on
the display. If the same error
message appears again on the
LCD, contact your local distributor
to call for service.
Correct the head height.
( page 2.6)
Close the station cover or release
the stop switch.
Replace a filter.
( page 3.10)
Contact your local MIMAKI
distributor or call a local MIMAKI
office for services. The parts
may be used until new parts are
delivered.