MIMAKI DM2-1810, Operation Manual

Page: 102 / 146

- 6.4 -
Problems where error messages are given on the LCD
If something is wrong with the machine, the buzzer sounds and a corresponding error message is
given on the LCD.
Take an appropriate corrective measure in accordance with the message.
Errors accompanied by warnings
These errors arise on the ink-related components.
Warning message Cause Corrective measure
Ink Cartridge
1 2 3 4 5 6 7 8 A B C D E F G H
Ink Near End
1 2 3 4 5 6 7 8 A B C D E F G H
Ink End
1 2 3 4 5 6 7 8 A B C D E F G H
Ink Low
1 2 3 4 5 6 7 8 A B C D E F G H
Wiper
Replace Wiper
Wiper
Clean Wiper Shaft
Waste Ink Tank
No Ink Tank
Waste Ink Tank
Ink Tank Is Full
Waste Ink Tank
Ink Tank Near Full
Ink cartridge is not loaded on
the ink station.
The amount of ink remaining in
the ink cartridge is insufficient.
The ink cartridge has run out of
ink.
Not enough ink for cleaning.
Time to replace the wiper in the
capping station with a new one
has come and clean the bottom
of the slider.
The wiper guide shaft is dirty.
Attach the ink cartridge(s)
corresponding with the number(s)
shown on the display.
Printing can continue by pressing
the [REMOTE] key. However, it
is recommended that you replace
the ink cartridge is shown on the
LCD with a new one.
Replace the ink cartridge shown
on the LCD with a new one.
Replace the ink cartridge of the
displayed number before cleaning.
Printing will be enabled by
pressing the [REMOTE]. Then, the
error message will not appear until
the power is returned on. It is
recommended, however, to replace
the wiper with a new one as soon
as possible.
Clean the wiper guide shaft.
Set the waste ink tank correctly.
Remove the waste ink tank and set
an empty waste ink tank.
The waste ink tank cannot be
found.
Waste ink tank is full.
Waste ink tank will soon full.