Milnor 72044 WP2, Service, Page: 39 / 202

<eRbYSQdY_^BUS_]]U^TQdY_^c
Di`U_V7bUQcU
—Use Shell Dolium R (factory installed) or Chevron SRI greases for standard
service conditions. The extreme and low temperature conditions are not normally encountered in the
laundry. However, for extreme conditions, use Darmex 707 and for low temperature conditions, use
Arrowshell 7. Contact Baldor for equivalents, if necessary.
3_bbUSd7bUQcU7e^@b_SUTebUc
Use hand-operated grease gun, not a pneumatic grease gun. Pump grease slowly, taking 10 to 12
seconds to complete each stroke.
Apply quantity of grease called for. Over-lubrication can be as damaging as under-lubrication.
Where quantities are stated in strokes, one stroke of the grease gun is assumed to provide .0624
fluid oz. (1.77 grams) (by volume) of grease. Therefore, one fluid ounce (28.3 grams) of grease
would be provided by 16 strokes of the grease gun. Determine the flow rate of your grease gun by
pumping one ounce into a calibrated container. If fewer than 16 strokes are required, all quantities
in strokes in the chart should be reduced accordingly. If more than 16 strokes are required, the
number of strokes should be increased. Before starting lubrication, make sure your grease gun
is working and that you get a full charge of grease with every stroke.
Do not over-lubricate motors. Over-lubrication of a motor can seriously damage it by forcing grease
into motor windings. Over-lubrication of the extract motor can force grease into the centrifugal
switch causing it to malfunction.
Do not allow grease to drip on the brake disk or clutch tire/drum during lubrication. This will reduce
the braking action considerably, and may permit the cylinder to creep while loading and unloading.
<eRbYSQdY_^@b_SUTebU
$
>?D935* =_d_b 4Q]QWU
C^ Pe^XS SP\PVT c^ \^c^a QTPaX]Vb VaTPbT \dbc QT ZT_c UaTT ^U SXac 5^a P]
TgcaT\T[h SXach T]eXa^]\T]c R^]cPRc h^da 1P[S^a SXbcaXQdc^a ^a P] PdcW^aXiTS
1P[S^a BTaeXRT 2T]cTa U^a PSSXcX^]P[ X]U^a\PcX^]
Clean grease fittings.
Remove grease outlet plug.
Add recommended amount of grease. Be sure grease to be added is compatible with the grease
already in motor. Consult your Baldor distributor or an authorized Baldor Service Center if grease
other than recommended is to be used. Stop when new grease appears at shaft hole in the endplate
or grease outlet plug.
Replace grease outlet plug.
21<4?B =?D?B =19>D5>1>35 =CC= "'$15)'#!1F$$