Milnor 72044 WP2, Service, Page: 19 / 202

<B8D?DC604(''0E
7\_ccQbi_VDQW9\\ecdbQdY_^c±
Cec`U^TUTGQcXUb5hdbQSd_bc
Illustration Explanation Illustration Explanation
Stop! Read the manual first for complete
instructions before continuing.
Do not jack the machine here.
Do not lift the machine here.
Use three point or four point lifting as
determined by the lifting eyes furnished. Rig
the load using lifting cables of sufficient size
a n d l e ng t h t o en sure cables are not
over-stressed.
Do not lift the machine from one corner or one
side edge.
Do not start this machine until the packing
materials, lifting brackets, etc. with this tag
attached or behind this panel are removed.
These materials are painted red. Safety stands
or brackets (also painted red) may be provided
with this machine. Do not discard safety
stands or brackets
Do not step or stand on this machine part.
Maintain a 25 mm. (1") minimum clearance
between float clips. Set "low level" so that the
bottom of the float is always at least 25mm
(1") above the bottom of the float tube.
This motor or pump should rotate in the
direction of the arrow.
This is the hot water inlet.