Page 20 or 34
Place the Gantry onto the Y Rails as pictured.
Place a V-wheel on an M5x25 machine screw,
followed by a standard spacer from the V-
wheel kit. Put the v-wheel into the V groove
of the extrusion before tightening the screw.
Screw the v-wheel into the bottom of the
Gantry Y Plate. It the fit is tight, use the
10mm wrench to adjust the eccentric spacers.
You may have to loosen the screws on the top
wheels to get the bottom wheel screws to line
up with the threaded hole.
Repeat the process for the other 3 V-wheels.
Use the 10mm wrench to turn the eccentric
spacers to give the v-wheels a good grip on
the extrusion. Tighten the v-wheels, being
careful not to turn the eccentric spacers when
you do.
This will secure the gantry assembly to the Y
rails. The gantry should smoothly roll forward
and back.
