Page 7 or 34
Place (2) eccentric spacers in the
Idler Side Gantry Plate (top
picture on previous page). Place
eccentric spacers with the thin
wall portion pointing to the top of
the Idler Side Gantry Plate. Put a
M5x30 machine screw through
the v-wheel, then through the
eccentric spacer. Secure with a
M5 nylock nut. Leave Snug, not tight. Repeat the process with
another v-wheel. Take careful note of which side of the place the
spacers and wheels are installed on.
Place the pillow block bearing on the Idler
Side Gantry Plate as pictured. Secure the
pillow block bearings with (2) M5x10
machine screws. Flip the plate
over.Screw in a M5 grub screw in the top
of an anti-backlash nut using a 3mm Hex
Key. Stop tightening when the grub
screw touches the bottom. Cap the grub
screw with a M5 jam nut. Repeat the
process for the second anti-backlash nut.
Place an anti-backlash nut on the plate as
pictured. Secure it with (2) M5x16
machine screws.
