Page 21 or 34
Insert a drop-in T nut into the Y Extrusion near the Rear Frame
as pictured. Grab a corner bracket. If it has a tabbed side and
a non-tabbed side, the tabbed side will fit into the slot on the
Rear Frame as pictured. It is okay if neither side has tabs.
Place an M5 split lock washer on a M5x16 machine screw,
place it through the corner bracket, then through the slot in
the Rear Frame. Secure with an M5 flat washer and an M5
nylock nut.
Place a M5 flat washer on a M5x10 machine screw. Put the
screw through the corner bracket and screw it into the drop-
in T nut. Tighten. Repeat the process on the opposite side of
the Rear Frame.
Grab a motor and a 3 Hole Motor Spacer Plate. Use the
Motor Spacer Plate to place the coupler on the motor in the
correct position. Use the 2.5mm Hex Key to tighten the
coupler. Repeat the process with the last motor and coupler.
You will have a long wire motor and a short wire motor
remaining.
When looking at the machine from the front, the
long wire motor will go at the back right and the shorter
wire motor will go to the back left.
