OM-281136 Page 41
B. Start Heating
1. Ensure all control thermocouples (TCs) are securely located under the attached heating tool and in positive contact with the part to be heated.
The attached TCs will display sensor temperatures
2. Press
[Run]
to start the heating process. The recording indicator will flash and the recording timer will display duration of the heat cycle.
3. When target temperature is reached under the heating tool, verify joint temperature is within range before welding.
4. Press
[Stop]
to end the heating cycle. A message is displayed asking if recording should be stopped. Select
[Stop Recording]
to end the
recording or
[Continue Recording]
to keep recording.
C. Bakeout Loaded Program
Figure 7-12. Bakeout Loaded Program
1. When on the Temperatures screen, press
[Bakeout]
to view the Bakeout menu.
2. While on the
Bakeout: OFF/ON
field, press
[Select]
to change from OFF to ON and enable the Bakeout process.
.
No changes are allowed on a loaded Bakeout program.
.
If output is already on, Bakeout will begin as soon as
ON
is selected.
3. Press
[Temperatures]
to return to the temperatures screen.
The Preheat menu has changed to the Bakeout settings.
When
[Run]
is pressed, the heater will ramp to the Bakeout Target Temperature, Soak for the programmed duration and Ramp down to the
