eGROSS pro-x
– eGROSS
MM137-004 - Operator Manual
51
2.4.2. Camera orientation
The camera's orientation can be modified according to the following pictures.
Please note that the pictures above show one side of the camera; repeat the same for the opposite side to
adjust the orientation.
Adjust the orientation of the camera so that the blue cutting board is centred when the minimum zoom level is
applied.
2.4.3. Turn ON the eGROSS pro-x unit
At this point the eGROSS unit can be connected to its power supply using the cable on the right-hand side
(looking at unit from the rear), as shown in the figure.
Then the power button on the lateral left side must be pressed as shown in the image below. This button is
also used to turn off the eGROSS unit. The Ethernet/LAN connection (for the eGROSS pro-x version only) can
be found next to the ON/OFF button.
Unit ON/OFF button
Ethernet/LAN connection
(for the eGROSS pro-x
only)
Two outlets
for connecting
instruments
Instrument
label
