If autodial does not exactly match an item in /ip telephony numbers, there can be two
possibilities:
•
if autodial is incomplete, rest of the number is asked (local voice port) or incoming call is
denied (VoIP)
•
if autodial is invalid, line is hung up (PSTN line), busy tone is played (POTS) or incoming
call is denied (VoIP)
Voicetronix Voice Ports
Home menu level: /ip telephony voice-port voicetronix
Property Description
name ( name ) - name given by the user or the default one
autodial ( integer ; default: "" ) - phone number which will be dialed immediately after the
handset has been lifted. If this number is incomplete, then the remaining part has to be dialed on the
dial-pad. If the number is incorrect, the line is hung up. If the number is correct, then the
appropriate number is dialed (the direct-call mode is used - the line is picked up only after the
remote party answers the call)
playback-volume ( integer : -48 ..48 ; default: 0 ) - playback volume in dB
• 0 - 0dB meand no change to signal level
record-volume ( integer : -48 ..48 ; default: 0 ) - record volume in dB
• 0 - 0dB meand no change to signal level
region ( name ; default: us ) - regional setting for the voice port. This setting is used for setting the
parameters of PSTN line, as well as for detecting and generating the tones
agc-on-playback ( yes | no ; default: no ) - automatic gain control on playback (can not be used
together with hardware voice codecs)
agc-on-record ( yes | no ; default: no ) - automatic gain control on record (can not be used together
with hardware voice codecs)
detect-cpt ( yes | no ; default: no ) - automatically detect call progress tones
balance-registers ( integer : 0 ..255 ; default: 199 ) - registers which depend on telephone line
impedance. Can be adjusted to get best echo cancellation. Should be changed only if echo
cancellation on voicetronix card does not work good enough. Echo cancellation problems can imply
DTMF and busy-tone detection failures. The value has to be in format bal1[,bal3[,bal2]], where
bal1, bal2, bal3 - balance registers. bal1 has to be in interval 192..248 (0xC0..0xF8). The others
should be in interval 0..255 (0x00..0xFF)
balance-status ( read-only: integer ; default: unknown ) - shows quality of hardware echo
cancellation in dB
loop-drop-detection ( yes | no ; default: yes ) - automatically clear call when loop drop is detected
Command Description
test-balance - current balance-registers value is tested once. Result is placed in balance-status
parameter. Balance can be tested only when line is off-hook. It won't work if line is on-hook or
there is an established connection ( name ) - port name to test balance of
Page 658 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
