MikroKopter OktoXL, Instruction Manual

Page: 56 / 74

Installation of the video transmitter
On the ARF-MikroKopter the appropriate video transmitter „NANO Stinger“, can be attached directly to the camera
mount SLR1/2. For this purpose a suitable clip for the video transmitter is included.
Step 1:
The cable for the video transmitter for strain relief is attached to the camera mount with a cable tie.
Step 2:
The video transmitter is with
the clip and with the
antenna is attached
to the carrier of the
camera mount.
ATTENTION :
Do not damage or crush the previously
attached cable on the carrier.
Step 3:
The wide connector needs to be plugged
into the video transmitter. The two-pin
BEC-connector is plugged to the BEC-coupling
on the bottom of the
ARF-MikroKopter .
Step 4:
The three-pin cable of the transmitter can be
connected now to the Mini-Camera or to
the Cinch-Molex Adapter.
Via the Cinch-Molex Adapter the
video signal (Composite) can be fed
from a camera/video camera
to the video transmitter.
The Mini-Camera can be installed to the camera mount and be either movable (pictured above)
or rigid (pictured below).
Page 52 HiSystems GmbH