MikroKopter OktoXL, Instruction Manual

Page: 33 / 74

Step 5: Connect the battery
The batteries of the transmitter and the ARF-MikroKopter should be fully charged.
Please note the order of switching on:
•
First set all switches on the transmitter to „OFF“ position and turn the transmitter on.
•
Then connect the battery of the ARF-MikroKopter .
Once the battery is connected to the ARF-Mikrokopter the initialisation begins.
This initialization of the ARF-Mikrokopter consists of two parts :
•
Each BL-Ctrl (Motor controller) on the ARF-MikroKopter checks its own connected motor. It turns each
connected motor a little bit and makes a tone sequence at the same time.
Also:
•
The buzzer at the copter begins to „beep“ directly after connecting the LiPo. After a short period of time a short
tone sequence sounds up again.
After initialization some values should be displayed in the KopterTool and the four buttons below the display should turn
to „green“.
Just in case no values are displayed, exit the KopterTool, start it again and eventually set up the COM-Port
again.
HiSystems GmbH Page 29
info
info
!