10
(2)
䖃
䖃
䖃
(1)
a.
b.
Assembly
Assemble with the reversed procedure
of disassembly, but be careful about
the following points.
Fix the wire (coupler) inside rear cover
(18) with cable tie certainly. (Fig. 6)
When installing the handle assembly to
the engine base, tighten 4 bolts (3) for the
handle brackets of right(1) and left(2) tem-
porarily. Then after adjusting the handle
operation with double nuts (14, 15),
tighten 4 bolts (3) completely. (Fig. 4)
Apply the grease to the shaft and washer.
Disassembly
Remove 4 bolts (35), then remove the belt
cover OUT (33). (Fig. 9)
Remove the V-belt (22).
e.
f.
g.
h.
i.
j.
Remove the wire terminal on engine side.
Remov e t he hose cla m p ( 3 3 ) , th e n
remove the hydraulic hose (51) from the
cylinder on vibrator side. (Fig. 5)
Remove the throttle wire on the engine.
Remove the hour and tachometer (96) on
the rear cover. (Fig. 6)
Remove 6 bolts (21), then remove the rear
cover (18). (Fig. 6)
Remove 4 bolts (3), then remove the
handle (16). (Fig. 4)
Before removing the hydraulic hose, clean
up dirt and soil on its connection part.
CAUTION
䟿
Be very careful not to have your finger get
caught by the hinge part.
CAUTION
䟿
When removing V-belt, after hanging the
waste cloth on the V-belt, then remove the
V-belt by rotating while pulling the waste cloth.
Be very careful not to have your finger get
caught.
In case of the V-belt have damage, it might be
broken by the pulling force. Your body might
damage due to this broken, so be very careful
about level of pulling force.
WARNING
䟿
䖃
䖃
Be very careful not to have your fingers
get caught by the hand pump spring.
Be very careful not to damage the wiring,
when pulling out the hand pump.
CAUTION
䟿
51
53
52
B
C
MVH-308
28
29
30
31
32
19
33
A
18
21
23
24
25
20
54
55
56
23
21
26 25
23
21
25
26
35
36
A
40 43
42
41
39
90
37
E
97
96
91
94
92
93
75
WHITE
ST
(BLACK)
B
(WHITE)
IG
(RED)
BLACK
D
RED
B
60
63
62
65
E
D
WHITE
GREEN
RED
BLACK
100
100
76
78
67
77
F
81
82
50
83
84
C
72
80
F
66
98
70
99
50
68
68-1
50
71
Fig.6
Fig.5
Hydraulic hose (51)
Cylinder
Hose clamp (33)
For Inspection and Charge of the hydrau-
lic oil, See the “9-8. Inspection & Change
of Hydraulic Oil”.
8.3 Main Body Part
(Separation Of Engine Base And
Vibrating Plate Assembly)
Fig.7
Waste cloth
V-belt(22)