19
Remove the spring holder with the spring
holder disassembling tool. (Fig. 44)
Loosen the two bolts of spring compres-
sion tool evenly. After making sure there is
no spring pressure, remove the spring
compression tool.
Remove the springs.
Degrease and clean the shaft of accumu-
lator, then remove the accumulator case.
(Fig. 45)
Remove the dust seal and O-ring from the
inside of accumulator case.
e.
f.
g.
h.
i.
Accumulator case
Shaft of accumulator
Fig.45
Fig.43
9840-10040
Disassembling tool
Fig.44
Assembly
Assemble with the reversed procedure
of disassembly, but be careful about
the following points.
Degrease and clean the each parts.
Be careful not to damage each parts,
during assembly.
Replace the O-ring and dust seal with a
new one.
Apply the molybdenum grease to the
O-ring, dust seal and sliding area.
Be careful to prevent entry of dust and for-
eign matter.
Assemble the dust seal and O-ring into the
accumulator case.
Put the lip of dust seal to the outside.
(Fig. 46)
Insert the accumulator case to the accu-
mulator shaft.
To prevent damage of the dust seal and
O-ring, apply the tape to the thread on
the end of accumulator shaft for pro-
tection. (Fig. 47)
Degrease and clean the thread on the end
of accumulator shaft, then apply 2 to 3
drops of Loctite #638. (Fig. 48)
(2)
䐟
䐠
䐡
䐢
䐣
a.
b.
c.
Tape
Fig.47
Fig.48
Dust seal
Fig.46