![background image](http://html1.mh-extra.com/html/mikasa/mvh-308-series/mvh-308-series_service-manual_1793895017.webp)
15
ղ
ճ
մ
յ
Insert the piston rod (13) from the piston
side (inside: tapered) of driven shaft, then
insert knock pin (14) into the hole of piston
rod through the groove of driven shaft.
(Fig. 28)
Put the eccentric rotator of driven shaft to
the upper side, then push the piston rod
into the driven shaft.
Put the punch mark of driven gear to the
pulley side, then insert it to the driven
shaft. At this time, set the driven gear by
turning its punch mark to the right side
when seeing from the pulley side. (Fig. 29)
By seeing from the pulley side, while rotat-
ing driven gear to the right, insert the
knock pin into the spiral groove of driven
gear.
In case of the driven gear is assembled
correctly, when pulling out the piston
rod, the punch mark of driven gear and
the threaded holes for eccentric rotator
of driven shaft should be set in the
same straight line. (Fig. 30)
Press fit the bearing (16), then fix the drive
gear (15). (Fig. 31)
Press fit the bearing inner to the driven
shaft (11).
The flange of bearing inner should put
to the eccentric rotator side.
Press fit the bearing outer of pulley side
from the inside of vibrator case with the
bearing insertion puller and bearing inser-
tion holder. (Fig. 32)
ն
շ
ո
Fig.28
Driven shaft (11)
Knock pin (14)
Push the piston rod
PULLEY SIDE
Knock pin (14)
PUNCH MARK
Fig.29
Pull the piston rod
The punch mark and threaded holes for
eccentric rotator are set in
the same straight line.
PUNCH MARK
Hole for
eccentric rotator
Hole for
eccentric rotator
Fig.30
Bolt
16
㽢
30(P1.5)(12)
Bearing (16)
PISTON SIDE (INSIDE:TAPERED)
PULLEY SIDE (INSIDE:STRAIGHT)
Driven shaft (11)
Eccentric rotator (6)
Fig.27
PRESS
Fig.31
Press fit the bearing (16)
Bearing
insertion puller
Bearing
insertion holder
OUTSIDE OF CASE
࣋ࣜࣥࢢ࢘ࢱ࣮
INSIDE OF CASE
Tighten the center bolt
Fig.32