Miele G 811, Operating Instructions Manual

Page: 14 / 60

Programming and setting the
water hardness level
Your water hardness must be pro-
grammed into the dishwasher using the
buttons on the control panel. The water
hardness selector in the wash cabinet
is then also set to correspond to the
water hardness level in your area.
Programming the water hardness
level
^
Turn off the dishwasher
^
Turn the program selector to “Stop”.
Hold the “Top Solo”-button in and and
at the same time turn on the dishwasher
with the “On/Off” button.Release the
“Top Solo” button within 2 seconds.
The “Salt” indicator flashes.
Note:
If any other indicators flash the process
must be repeated.
Except:
The “Rinse aid” indicator will light when
the reservoir is empty and needs to be
refilled.
^
Turn the water hardness level selec-
tor to the corresponding setting
(see table below).
gr/gal ppm Selector setting
1 - 5 20 - 90 Normal 55 °C/130 °F
6 - 8 110 - 140 Sani Wash
9 - 11 160 - 220 Normal 65 °C/150 °F
12 - 16 220 - 290 Light Wash 55 °C/130 °F
17 - 21 310 - 380 5 o’clock position
22 - 24 400 - 430 6 o’clock position
25 - 31 450- 560 7 o’clock position
32 - 70 580 -1260 Energy saver
The water hardness level is preset to
1 - 5 gr/gal (20 - 90 ppm).
Example:
If the water hardness level is
10 gr/gal select setting “Normal
65 °C/150 °F”.
Before using for the first time
14