Problem solving guide
99
Issue
Cause and remedy
At the end of the
programme, the display
shows the following
message:
Fault F601
There is a fault in the AutoDos.
Switch the dishwasher off and back on again.
Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see
“Detergent – Automatic dispensing/AutoDos”).
Activate the
AutoDos
function and start the
programme again.
If the fault message appears again, there is a
technical fault. You can continue to use your
dishwasher by deactivating automatic dispensing
using the
AutoDos
button and manually
dispensing the detergent via the detergent
compartment.
If you wish to use automatic dispensing again,
contact the Miele Customer Service Department.
At the end of the
programme, the display
shows the following
message:
AutoDos maintenance
The dishwasher does
not switch off at the end
of the programme.
The crockery may not
be clean because an
insufficient amount of
detergent was
dispensed.
The
AutoDos
function is
automatically
deactivated during the
programme sequence.
An empty PowerDisk has been inserted or the
AutoDos is blocked by residual detergent. Detergent
dosage is insufficient.
The
AutoDos
function was automatically
deactivated.
Switch the dishwasher off and back on again.
Multiple messages appear in the display.
Clean the fill channel of the AutoDos (see
“Detergent – Cleaning the AutoDos”).
Clean the lower spray arm (see “Cleaning and care
– Cleaning the spray arms”).
Select
OK
to confirm each message.
Activate the
AutoDos
function by confirming the
message
AutoDos available
using
OK
.
Start the programme again.
The programme sequence will be extended by up to
2.5 hours to flush out the AutoDos detergent outlet.
