30 CropHawk Draper Platform Operators Manu-
Removable Components
Sand Trap
Nose Cones
Crop Dividers
Sand Trap Removal
IMPORTANT: Ensure ram safety stops are engaged when working under Platform.
Sand Trap (see image) is located under the centre feed
belt and can be removed to clean out any build up of de-
bris. It is recommended to be removed for operation in
short crop conditions where soil is causing centre feed belt
to stall.
1.
Remove 5 x bolts (A).
2.
Loosen 2 x bolts (B).
3.
Remove sand trap and clear debris.
4.
Replace sand trap if removed for cleanout.
5.
Retighten 7 x bolts (A&B) .
NOTE: Bolts that retain the sand trap also retain the crop throat floor sheet and under feed shield. When ad-
justing or removing the sand trap ensure floor sheet and under feed shield maintain position (if movement has
occurred see CROP FLOOR SHEET in this manual).
Nose Cone Fitment
1.
Place 2 x bolts (A) in and hand tighten.
2.
Before proceeding ensure that inside surface is flush with side and
the top surface is flush with platform. If not adjust to suit.
3.
Once in position tighten bolts (A).
4.
Place and tighten 3 x remaining bolts.
Crop Divider Fitment
1.
Slide crop divider (see image) into Nose Cone.
2.
Place bolt (A) with washer from underneath.
3.
Tighten nut through hole in nosecone onto crop divider.
B
A
A
A
Continued on next page
