CropHawk Draper Platform Operators Manual 73
Lubrication Interval Chart
grease
pumps
10 Hrs
50 Hrs 250 Hrs 500 Hrs
Check hydraulic tank oil level
n/a
#
Check accelerator gear box oil level
n/a
#
Reel axle pivot bushes x 2
AR
#
PU Reel pitch bushes x 2
AR
#
Reel arm brace x 2
1
#
Adapter pivot
5
#
Drive box input PTO
3
#
Feed Drum PTO
3
#
Ground Wheel Caster x 2
AR
#
Knife Drive gear box x 2
5
#
Knife Head bearing x 2
1
#
Split reel centre universal
3
#
Split Reel Centre bearing
3
#
Bottom input shaft bearings x 2
2
#
Knife shaft bearings x 6
2
#
Change hydraulic oil filter
n/a
#
3
#
Feed Drum Clutch
Ground wheel hub
10
#
Lubrication / General Maintenance
Daily pre start checks
Lubricating the Draper Platform
All Knife Drives are lubricated with Grease only. Occasionally some grease may escape through the gap
between the rotor bottom housing; however this in normal and no cause for alarm. Use only lithium
based extreme pressure, high temperature grease.
AREA
LUBRICANT TYPE
VOLUME
OIL CHANGE
Hydraulic system
AW68 Hydraulic oil
70L
500 hours
Accelerator Gear box
75W-85 Synthetic oil
300ml
250 hours
Grease points
Multi purpose, extreme pressure,
high temperature grease.
As Recommended
As Recommended
Before operating the Platform complete the following check list:
Visual check for any damage to platform
Clean debris build up from platform
Lubricate platform (see Lubrication Chart be-
low)
Check hydraulic system for leaks
Check Draper belts for damage/obstructions
Check Draper belts for tracking and tension
Check all Drive Belt tensions and alignments
Check Reel chain drive tension
Check tyre pressure