![background image](http://html1.mh-extra.com/html/midwest/crophawk-draper-platform/crophawk-draper-platform_operators-manual_1792989050.webp)
50 CropHawk Draper Platform Operators Manu-
Continued on next page
Drive System
Service / maintenance
Clutch Friction Plate Removal and Replacement
1.
Remove clutch (Refer to KNIFE CLUTCH REMOVAL section in this manual).
2.
Remove RH threaded shaft (A).
3.
Loosen 3 bolts (B) in adjuster ring.
4.
Remove adjuster ring (C).
5.
Remove convoluted spring locator (D).
6.
Remove both convoluted springs (E).
7.
Remove pressure plate (F).
8.
Remove outer friction plate (G).
9.
Remove clutch (H).
10.
Inspect internal clutch bearings and replace if necessary .
11.
Remove inner friction plate (I).
12.
Assembly is the reverse of steps 1-10.
13.
Tighten adjuster ring 2/3 of a turn after contact with the spring locator.
14.
Tighten 3 adjuster ring bolts (B) to 1mm from bottoming .
15.
Refit RH threaded shaft (A) ensuring clean and proper seating of taper.
16.
Reinstall clutch. (Refer to KNIFE CLUTCH REMOVAL and INSTALLATION section).
A
B
D
F
H
I
G
E
C