![background image](http://html1.mh-extra.com/html/midea/tm05k6bw-p/tm05k6bw-p_instruction-manual_1791428035.webp)
Wall
Mounting
Plate
Spacing for Toggles
More Than Wall
Thickness
Bolt End
Toggle
Bolt
Toggle Wings
35
To use toggle bolts:
C2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a hole large enough for the power cord
to fit through, and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
Place the mounting plate against the wall and insert the toggle wings into the holes in the
wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw, make sure the bottom of the
mounting plate touch the bottom of the cabinet when pushed flush against the wall and
that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate
and the wall.
4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.
C. ADAPTING MICROWAVE BLOWER FOR OUTSIDE TOP EXHAUST
1. Place the microwave in its upright position, with the top of the unit facing up.