![background image](http://html1.mh-extra.com/html/midea/tm05k6bw-p/tm05k6bw-p_instruction-manual_1791428018.webp)
18
Adaptor in Place for
Outside Top Exhaust
C. OUTSIDE TOP EXHAUST (VERTICAL DUCT)
A. RECIRCULATING (Non-Vented Ductless)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Blower Plate
A4. Mount the Microwave Oven
A5. Install or change Charcoal Filter
IMPORTANT NOTES:
• Make sure the screws for the blower motor and blower plate are securely tightened when
they are reinstalled.
This will help to prevent excessive vibration.
• Make sure the motor wiring has been properly routed and secured, and that the wires are
not pinched.
NOTE: Read the pages 14-15 only if you plan to vent your exhaust to the outside.
If you plan to recirculate the air back into the room, proceed to page 10.
See page 20
3/8" TO EDGE
NOTE: IT IS VERY I
MPORTANT TO
READ AND FOLLO
W THE DIRECTION
S
IN THE INSTALLAT
ION INSTRUCTION
S
BEFORE PROCEEDING
WITH THIS
REAR WALL TEMP
LATE.
This Rear Wall Templa
te serves to position th
e bottom
mounting plate and to
locate the horizontal ex
haust
outlet.
1. Use a level to check
that the template is pos
itioned
accurately.
2. Locate and mark at l
east one stud on the le
ft or
right side of the cen
terline.
It is important to use a
t least one wood
screw mounted firmly i
n a stud to support the
weight
of the microwave. Mar
k two additional, evenly
spaced
locations for the suppl
ied toggle bolts.
3. Drill holes in the mar
ked locations. Where t
here is
a stud, drill a 3/16" h
ole for wood screws. F
or holes
that do not line up w
ith a stud, drill 5/8" hole
s for
toggle bolts.
DO NOT INSTALL TH
E MOUNTING PLATE
AT THIS TIME.
4. Remove the templa
te from the rear wall.
5. Revie
h
t
w
e Installation Instruction b
ook for your
installation situation.
Locate and mark ho
les to align with holes
in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST
ONE STUD ON EIT
HER SIDE OF
THE CENTERLINE.
MARK THE LOCATIO
N FOR 2 ADDITION
AL, EVENLY
SPACED TOGGLE B
OLTS IN THE MOU
NTING PLATE
AREA.
Locate and mark hol
es to align with holes
in the
.
e
t
a
l
p
g
n
i
t
n
u
o
m
IMPORTANT:
LOCATE AT LEAST ON
E STUD ON EITHER
SIDE OF
THE CENTERLINE.
MARK THE LOCATIO
N FOR 2 ADDITION
AL, EVENLY
SPACED TOGGLE
BOLTS IN THE MO
UNTING PLATE
AREA.
Trim the rear wall te
mplate along the do
tted line.
Trim the rear wall t
emplate along the
dotted line.
12"
4"
Darle vuelta a la hoja
para consultar la
versión en Español.