27
B. OUTSIDE BACK EXHAUST (Horizontal Duct)
B1. PREPARING THE REAR WALL FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for outside exhaust.
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Remove Blower Plate
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
• Make sure the screws for the blower motor and blower plate are securely tightened when
they are reinstalled. This will help to prevent excessive vibration.
• Make sure the motor wiring has been properly routed and secured, and that the wires are
not pinched.
3/8" TO EDGE
NOTE: IT IS VERY IM
PORTANT TO
READ AND FOLLOW
THE DIRECTIONS
IN THE INSTALLATION
INSTRUCTIONS
BEFORE PROCEEDIN
G WITH THIS
REAR WALL TEMPLA
TE.
This Rear Wall Templ
ate serves to position th
e bottom
mounting plate and to l
ocate the horizontal ex
haust
outlet.
1. Use a level to check
that the template is pos
itioned
accurately.
2. Locate and mark at
least one stud on the le
ft or
right side of the cen
terline.
It is important to use a
t least one wood
screw mounted firmly i
n a stud to support the
weight
of the microwave. Mar
k two additional, evenl
y spaced
locations for the suppl
ied toggle bolts.
3. Drill holes in the ma
rked locations. Where t
here is
a stud, drill a 3/16" h
ole for wood screws. F
or holes
that do not line up w
ith a stud, drill 5/8" hole
s for
toggle bolts.
DO NOT INSTALL TH
E MOUNTING PLATE
AT THIS TIME.
4. Remove the templa
te from the rear wall.
5. Revie
h
t
w
e Installation Instruction b
ook for your
installation situation.
Locate and mark holes
to align with holes in t
he
mounting plate.
IMPORTANT:
LOCATE AT LEAST
ONE STUD ON EIT
HER SIDE OF
THE CENTERLINE.
MARK THE LOCATIO
N FOR 2 ADDITIONA
L, EVENLY
SPACED TOGGLE BO
LTS IN THE MOUNTING
PLATE
AREA.
Locate and mark ho
les to align with holes
in the
.
e
t
a
l
p
g
n
i
t
n
u
o
m
IMPORTANT:
LOCATE AT LEAST ON
E STUD ON EITHER SI
DE OF
THE CENTERLINE.
MARK THE LOCATIO
N FOR 2 ADDITIONA
L, EVENLY
SPACED TOGGLE BO
LTS IN THE MOUNTING
PLATE
AREA.
Trim the rear wall templat
e along the dotted line
.
Trim the rear wall t
emplate along the dot
ted line.
12"
4"
Darle vuelta a la hoja
para consultar la
versión en Español.
• Read the instructions on the REAR WALL TEMPLATE.
• Tape it to the rear wall.
• Cut the opening, following the instructions of the REAR WALL TEMPLATE.
