Page 15
Other features
Bucket Full Light
Glows when the bucket is ready to be emptied, or
when the bucket is removed or not replaced in the
proper position.
Auto Defrost
When forst builds up on the evaporator coils, the
compressor will cycle off and the fan will continue to
run until the frost disappears.
Note: When Auto defrosting operation, the unit may
make a voice of refrigerant flowing, it is normal.
proper position. For some models, the fan motor will
continue to run for 30 seconds.
Auto Shut Off
The dehumidifier shuts off when the bucket is full, or
when the bucket is removed or not replaced in the
Wait 3 minutes before resuming operation
After the unit has stopped, it can not be restart
operation in the first 3 minutes.This is to protect the
unit. Operation will automatically start after 3 minutes.
Setting the Timer(With 1 indicator light)
·
Press to initiate the Auto start or Auto stop feature, in
conjuction with the UP and DOWN buttons.
· When the unit is on, press the Timer button to
actieve the Auto Stop feature. When the unit is
off, press this button to actieve the Auto start
feature.
· Press or hold the UP or DOWN button to
change the Auto time by 0.5 hour increments,
up to 10 hours, then at 1 hour increments, up
to 24 hours. The control will count down the
time remaining until start.
· The selected time will register in 5 seconds and
the system will automatically revert back to
display the previous humidity setting.
Display
Shows the set % humidity level from 35% to 85% or
auto start/stop time (0~24) while setting, then shows
the actual(±5% accuracy) room % humidity level in a
range of 30% RH(Relative Humidity) to 90%RH(Relative
Humidity).
Error Codes:
AS-Humidity sensor error--Unplug the unit and plug it
back in. If error repeats, call for service;
ES-Temperature sensor error-- Unplug the unit and
plug it back in. If error repeats, call for service;
P2-Bucket is full or bucket is not in right position--
Empty the bucket and replace it in the right
position.
P1-Unit is defrosting--Allow the unit time to
automatically service. The protection will clear after
the unit self defrosts. (On some models)
E4-Display panel communication error--Unplug the
unit and plug it back in. If error repeats, call for
service. (On some models)
Operating
Instructions
reducing the risk of mould and bacterial growth. To
disable the function, press the Pure pad for 3 seconds
or select an operating mode with the Mode pad.
Press the Turbo pad for 3 seconds to enable this
function. This function initiates as soon as the unit is
switched off, and runs 15 minutes under high fan
speed.
Self-clean(On some models)
This function significantly reduces the dust, bacteral
and allergen content of the room, using the HEPA(High
Efficiency Particulate Air) filter supplied with the unit.
Press the Pure pad to activate
the Air purifier function,
all other modes and special
functions are inhibited while
it is running. Make sure you
have fitted the HEPAfilter as
indicated in fig.A.
Air purifier function(On some models)
HEPA filter
Air intake grill
Auto-Restart
If the unit breaks off unexpectedly due to the power
cut, it will restart with the previous function setting
automatically when the power resumes.
Smart dehumidifying mode(On some models)
At smart dehumidifying mode, the unit will
automatically control room humidity in a comfortable
range 45%~55% according to the room temperature.
The humidity setting function will be invalid.
Anti-mould function(On some models)
Press the Pure pad for 3 seconds to enable this
function. This maximises occupant comfort while
