Removing the collected water
Auto Stop program is initiated. Press it again the
Timer On indicator light illuminates. It indicates the
Auto Start is initiated.
· When the unit is off, first press the Timer
button, the Timer On indicator light
illuminates. It indicates the Auto Start program
is initiated. Press it again the Timer Off indicator
light illuminates. It indicates the Auto Stop is
initiated.
· Press or hold the UP or DOWN button to
change the Auto time by 0.5 hour increments,
up to 10 hours, then at 1 hour increments, up
to 24 hours. The control will count down the
time remaining until start.
· The selected time will register in 5 seconds and
the system will automatically revert back to
display the previous humidity setting.
· When the Auto start & Auto stop times are set,
within the same program sequence, Timer On
Off indicator lights illuminate identifying both
On and Off times are now programmed.
· Turning the unit On or Off at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop function.
· When LED display window is plays the code of
P2, the Auto Start/Stop function will also be
cancelled.
Setting the Timer(With 2 indicator lights)
·
When the unit is on, first press the Timer button, the
Timer Off indicator light illuminates. It indicates the
· Turning the unit On or Off at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop function.
· When LED display window is plays the code of
P2, the Auto Start/Stop function will also be
cancelled.
There are two ways to remove collected water
.
1. Use the bucket
· When the unit is off,if the bucket is full, the unit will
beep 8 times(on some models) and the Full Water
indicator light will flash.
· (For some models)When the unit is on,if the bucket is
full, the compressor turns off and the fan turns of f after
30 seconds for drying the water of the condenser , then
the unit will beep 8 times and the Full Water indicator
light will flash.
· Slowly pull out the bucket. Grip the left and right
handles securely , and carefully pull out straight so
water does not spill. Do not put the bucket on the
floor because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water to
spill.
· Throw away the water from the water outlet and
replace the bucket. The bucket must be in place and
securely seated for the dehumidifier to operate.
· The machine will re-start when the bucket is restored
in its correct position.
Operating
Instructions
Dryer mode(On some models)
Page 16
do not open the door and window.
2. To make the best effective
dehumidification, please first
dehydrate the wet clothes.
3. Make sure to direct airflow
at the wet clothes.
4. For thick and heavy wet
clothes may not get the best
effective dehumidification.
Note:
1. The dryer mode must be operated in a close room,
30~50cm
Wet clothes
30~50cm
Airflow
Allow 30~50cm
of distance on the
top and right side
of the unit to the
wet clothes.
1. Pull out the bucket a little.
The unit can make the MAX dehumidification function
when it is under Dryer mode. The fan speed is fixed at
high fan speed. For some models,The unit will quit dryer
mode after a maximum 10 hours’ operation.
