Middleby Marshall RED LOBSTER PS200-R68 Series, Operating And Installation Manual

Page: 55 / 88

49
SECTION 4
MAINTENANCE
Middleby
Marshall
Middleby
Marshall
e. Checking conveyor belt tension.
NOTE: Oven conveyor belt must be cool when adjusting belt.
Do not adjust belt if HOT.
AA. With the conveyor assembly in the oven, stand at one end
of conveyor and check tension by lifting the conveyor belt at
the center of the oven chamber opening. The belt should not
lift higher than 3 to 4 inches (76mm to 102mm).
BB. Adjust conveyor chain tension screws (located on left end
of oven) for the 3" to 4" deflection shown in the photo.
CC. If conveyor belt is still not under proper tension recheck
your adjustment of the conveyor tension screws. If correct
adjustment is not possible call your service agency.
Figure 4-29.
Figure 4-30.
f. Reinstall conveyor end stop
and rear stop.
7. Reassemble upper end plugs to
both ends of oven. Refer to Figure
4-30. Notice that the upper end plug
is not notched. Secure the end plugs
to oven using the wing nuts.
Conveyor
End Stop
Conveyor
Rear Stop
Removable
Crumb
Pans
Removable
Crumb
Pans
Notch In Lower
End Plug
Lower End
Plug