Middleby Marshall RED LOBSTER PS200-R68 Series, Operating And Installation Manual

Page: 58 / 88

52
SECTION 4
MAINTENANCE
Figure 4-34.
3. If belt is loose or to replace belt loosen the tension
locking bolts on the motor mounting bracket. Next pull
back on the motor, do not over tighten or fan bearings
may be damaged. Retighten locking bolts.
Figure 4-35.
D. Main Blower Fan Shaft Bearing Lubrication
Grease the 2 main blower fan shaft bearings using a
special high temperature grease (MM P/N 17110-
0015 Lithium base higher temperature grease). ONLY
ONE PUMP of grease gun in each bearing is required.
Over greasing will damage bearing seals which will
accelerate grease loss and shorten bearing life. Wipe
off any excess grease on and around the bearing.
Replace rear shroud, oven will not operate without the
rear shroud in place.