122
(6) Roller bar.
In the decode data area, the stop bit error data is displayed in yellow, and the decode error data is displayed
in red;
12.2 LIN Bus Trigger and Decode
For correctly decoding LIN bus data and making trigger stable, the bus configuration, trigger mode set and trigger
level need to be adjusted.
⚫
Bus configuration
Press
or
to open the bus configuration menu, and the following need to be set according to
measured signal:
Source — Select the signal source of decode.
Idle-level - high and low. Select whether to display high active or low active after the signal start bit of
measured equipment.
BaudRate — Select the baud rate that matches the signal being measured, and it can be customized.
The setting method is the same as that of UART, and will not be repeated here. As shown in Figure 12-10:
Figure 12-9 LIN Bus Configuration Menu
⚫
Trigger mode
Open the trigger configuration menu and select the appropriate trigger type. When the LIN bus trigger is
selected, the trigger mode includes: Sync-Rising, Frame ID, ID + Data. See Figure 12-11:
