Routine Operation
3-59
DVC4000
Operator’s Guide/Tech Ref Manual
Figure 3-164: Preset Menu
8.
Press the Up or Down arrow keys, as required, to
move the cursor to the
Recall Preset
option. Observe
the cursor changes to a
>
cursor.
9.
Press the
SEL
key or Right arrow key and observe the
Recall Preset
option changes to
#X:Preset #X
, as
shown in
Figure 3-165
, and the
>
cursor changes to a
!
cursor.
Figure 3-165: Recall Preset Option
10.
Press the Up, Down, Left, or Right arrow keys to select
Preset
1
thru
9
, as required, and press the
SEL
key.
11.
Press the
ESC
key repeatedly until the Main Screen is
displayed.
12.
Press the Up arrow key to move the
>>
cursor to the
MPEG Decoder
option.
13.
Press the
SEL
key or Right arrow key and observe the
MPEG Decoder
menu is displayed.
14.
Press the Up or Down arrow keys, as required, to
select the
Attn:
option and observe the cursor
changes to a
>
cursor.
See Figure 3-166
.
Preset Menu
* #X:Preset #X
Save Settings
Recall Preset
Preset Menu
Save Settings
! #X:Preset #X
Figure 3-166: MPEG Decoder Menu - Typical
15.
Press the
SEL
key or Right arrow key and observe the
>
cursor changes to a
!
cursor.
16.
Press the Up, Down, Left, or Right arrow keys, as
required, to select the attenuation level required. The
attenuation range is 0.0 to 6.0 dB.
17.
Press the
SEL
key and observe the
!
cursor changes
to a
>
cursor.
18.
Press the
ESC
key and observe the Main Screen
menu is displayed.
3.6.16
Monitor Audio A Rate
To monitor Audio A audio rate, perform the following steps for
each Preset, as required:
Note
In order to monitor Audio A audio rate when
performing the following steps, the DVC4000-D
must be powered up and must have video stream
inputs into the rear panel
ASI IN
connector.
1.
Verify the DVC4000-D is powered up.
2.
Verify the Main Screen menu is displayed.
See
Figure 3-167 on page 3-60
. If the Main Screen is not
displayed, press the
ESC
key repeatedly until the Main
Screen is displayed.
MPEG Decoder
Audio Out: Ana
> Attn: X.X dB
Aud A: Stereo
