DOC 6501_Release V
ATS-6501 Users Guide
155
bitcode_port
Description:
This command configures one or more of the ports on the specified
TSC4391A output card.
To set the Port parameters use the
bitcode_port
command and
specify the stream (1-4) and the blanking type. Users can enable/disable the stream using
the --enable false (off) or true (on). The example below assigns stream 3 to ports 1 and 3
on the card in slot 5
Usage:
bitcode_port --stream STREAM --blanking <none|zeroes|ones> --enable
<true|false> SLOT [PORTLIST]
•
--stream: Bit generation stream to assign to the specified port(s). If not specified, the
assigned stream remains unchanged.
•
--blanking: Blanking mode for the specified port(s). Must be “none”, “zeroes”, or
“ones”. If not specified, the blanking mode remains unchanged.
•
--enable: Enables or disables the specified port(s). If disabled, an output is electrically
isolated from its associated bit generator output. If not
specified, the enable
state(s) remains unchanged.
•
SLOT: Slot number of the TSC4391A output card to be configured. SLOT must be an
integer between 1 and 6.
•
PORTLIST: Port number(s) to configure. PORTLIST must be a comma-delimited list
of ports, each of which is an integer between 1 and 4. If not specified, the command
shall apply to all ports on the TSC4391A output card. If only 1 port is specified, no
comma is necessary.
Command Example:
ATS-6501>bitcode_port --stream 3 --blanking none --enable true 5 1,3
Query:
ATS-6501>settings hardware:slots:5:tsc4391:ports
[1]
[blanking] none
[enabled] true
[stream] 3
[2]
[blanking] none
[enabled] true
[stream] 2
[3]
[blanking] none
[enabled] true
[stream] 3
[4]
[blanking] none
[enabled] true
[stream] 4
[OK] 2014-04-29T23:45:58Z