22
Service Manual
www.microphase.eu
Dc
The following diagram shows an tipical application utilizing a Dc One with Brush motor. The + M
and -M output are identified on the POWER connector of the product.
In this case the drive is feedback from encoder. The inputs signal encoder of the drive" ENC A and
ENC B" are refer with the zero control signals of CNC.
To obtain good dynamic performance of the motor, we recommend the use of encoders with at
least 2000/2048PPR. Acceptable performance is obtained anyway even with the use of encoders
500/512PPR.
Is possible to use the +5V output "terminal 12" for the supplies the encoder. Note: the maximum
load on teV is 130mA.
Note:
- Don't use terminal 15.
- For terminal input 14 (+Limit switch) and terminal input 16 (-Limit switch) see page 34.
4.1 Brush motor with encoder feedback
D
C
O
N
E
X
L
CNC
