Glue the sides of the fuselage to the base plate as shown.
They will sit flush with bulkhead sides and brace and be on a slight angle.
Glue these foam pieces to the bottom
of the base plate. Because the balsa
wood sides are attached at an angle there will
be a small gap between the sides and the foam
pieces.
If you intend installing an FPV camera you can mount the camera at this stage. We recommend
camera systems similar to the one shown here which weighs 4.5 grams. See the
website for more info on this FPV setup.
Glue in place the camera supports. The slot allows you to install the camera without unsoldering.
With the canopy in place check that the canopy
former clears the top of the camera.
Also check if you need to add some packing
under the camera to allow the lens to clear the
balsa part at the front of the canopy.
Video Link
Video Link
Video Link
