Apply hinge tape such as Blenderm Hinge Tape
to the bottom surface of the wing. Remember
that on this model the control surface bevel is
on the top of the control surface.
Bend the tape down with your fingers as
you position the control surface 0.5mm
away from the wing. Then allow the tape
to come in contact with the control surface.
Ensure there is 1mm gap between the control
surface and the wing tips.
Run a piece of model masking tape from the
under-side of control surface onto the wing tip
fin. This sets the bottom edge of the control
surface level with the bottom edge of the fin.
Ensure your trims are set to neutral before
attaching the control linkages.
Flush with bottom
1mm gap
Video Link
Video Link
Video Link
