Apply UHU Por Expanded Polystyrene
glue to the following parts.
Bottom surface trailing edge of the wing first.
Then the foam rib on the fuselage
Then to the fronts and top of each rib
The top of the carbon spar.
As before, gently work the wing’s top surface
into place and clip it over the rib tabs. Ensure it
is seated correctly at the fuselage and the wing
tip.
Note that the wing tip will have a slight upward
deflection in this area. The shape of the wing
tip rib causes this and it is intended to give a
similar effect to washout on the tip of the wing.
Glue the remaining piece of the fuselage
in place. Use a little glue as possible so
it doesn’t squeeze out on the inside of the
fuselage where the canopy needs to slide in.
Also make sure that the triangle shaped
wooden brace is on the outer sides.
Continue with the same procedure for the other wing.
Once fully dry, working on the edge of a table
again, lightly sand the trailing edge of the wing
at a shallow angle. Sand back to the first rib
tab.
Video Link
Video Link
Video Link
Video Link