Sand a bevel into the sides of
the fuselage sides.
Glue the fuselage sides in place.
Apply glue to the balsa frame and
secure the foam sides in place.
Use a match to scrape off any excess glue from
the exposed balsa areas.
Two canopy covers are supplied in the
kit
–
one with a hole at the front for an
FPV camera and another without.
Use the one you need for your application and
bend along the half-cut lines as before.
Glue the canopy cover in place starting at the front. Use model masking tape to hold it in place as
it dries. Also glue in place the bulkhead air flange.
Glue the inner foam ribs in place as shown.
With bevel sanded
Clear glue from exposed balsa
Flush top and bottom
with the carbon rod here
Video Link
Video Link
Video Link
Video Link
Video Link
