© Microhard Systems Inc.
46
4.0 Configuration
Image 4-3-2: Carrier > Settings
4.3.2 Carrier > Settings
The parameters within the Carrier Configuration menu must be input properly; they are the most basic
requirement required by your cellular provider for network connectivity. The IPn3Gii/4Gii can support dual
SIM cards, as described below either slot can be specified as the primary slot and if a connectivity issue
occurs, the unit can be configured to automatically switch to the alternate SIM card.
Carrier Status is used to Enable or Disable the connection to the
Cellular Carrier. By default this option is enabled.
Carrier Status
Values (Selection)
Enable
/ Disable
IP pass-through allows the WAN IP address to be assigned to the
device connected to the LAN or WAN ports. In this mode the Bullet is
for the most part transparent and forwards all traffic to the device
connected to the selected Ethernet port except that listed below:
The WebUI port (
Default Port:TCP 80
), this port is retained for
remote management of the Bullet. This port can be changed to a
different port under the
System > Services
Menu.
The SNMP Listening Port (
Default Port: UDP 161
).
The virtual IP address is configurable to allow access to the unit on the
LAN/WAN connector once IP-Passthrough has been enabled.
The firewall/rules must be configured to allow traffic, all incoming
carrier traffic is blocked by default.
IP-Passthrough
Values (Selection)
Disable
Ethernet (LAN)
WAN
