Micro
dome Duo®
Installation Manual
Page | 22 [email protected]
+1.818.937.0700
|
877.CAMERA.8
|
www.arecontvision.com
|
Camera Power Up using PoE
This product should be installed by a qualified service technician in accordance with the National Electrical
Code (NEC 800 CEC Section 60) or applicable local code. Make sure that your installation of wires complies
with Electrical Code of the local government where the camera is installed and no bare wires are exposed.
1. Remove cover from the camera as described on page 6.
2. Plug one end of Ethernet cable into female end of pre-installed camera Ethernet cable.
3. Plug opposite end of Ethernet cable into PoE port on 100Mbps Poe switch, Cat 5e or Cat 6 cables are
recommended.
4. Observe the yellow and green lights on Main Board PoE connector for connection status
LED
Status
Description
Yellow
Flashing
Link has been established.
Solid
Normal Operation.
Green
Flashing
Camera has been accessed. Normal operation.
Solid
N/A
None
None
No Connection.