Page 85
Appendix | ASCII Communication with Sensor
optoNCDT 1220
A 3.3.5.3 MEASSETTINGS, Load / Save Measurement Settings
MEASSETTINGS <Subcommands> [Name]
Settings of the measurement task.
Loads proprietary presets and one user-specific setting from the sensor or stores one user-specific setup in
the sensor.
Subcommands:
CURRENT: Output of the name of current measurement setting
PRESETLIST: Listing of all existing presets (names): „Standard“, „Multi-Surface“, „Light Penetration“.
LIST: Listing of all saved measurement settings (names) “Name1” “Name2” “...”.
READ <Name>: Loads a preset or a measurement setting from the sensor.
STORE <Name, new>: Saves the current measurement setting in the sensor.
DELETE <Name>: Deletes a measurement setting
RENAME <NameOld> <NameNew> [FORCE]: Renaming a measurement setting. An existing mea-
surement setting can be overwritten with FORCE.
INITIAL AUTO: Loads the last saved measurement setting at the start of the sensor.
INITIAL <name>: Loads a named measurement setting at the start of the sensor.
PRESETMODE: Returns the set signal quality
PRESETMODE <Mode>: Setting the signal quality. Setting the signal quality is possible only, if a preset
was loaded.
•
<mode> = BALANCED|DYNAMIC|NOAVERAGING
Names:
<name> Name of a manufacturer setup or a user-specific setup.
<name new> Name of a user-specific setup. Names must have at least two characters and are limited to
max. 31 characters. Letters from A to Z without umlauts and numbers are allowed, the name is case-sensitive.
Preset names are not permissible, a name should not begin with “Auto”.
Summary of Contents for ILD 1220-10
Page 8: ...optoNCDT 2300...
Page 93: ......
