Smart Swing 3
®
Installation Manual
SMART SWING 3 ®
Page 21 of 36
-
Used for correct door latching, when the pressures on the door prevents it from fully closing.
-
Use the “UP” and “DOWN” buttons to disable or enable this feature
Warning
: Please note when using power close safety sensor must be used
7.1.17 Reverse on obstruction (NO/YES)
-
This setting will disable/enable the door re-activation feature.
-
If enabled, a re-activation is generated if the door encounters an obstruction for at least 2 seconds, during the closing
cycle (Between backcheck and the latch area)
7.1.18 This door overlaps? (NO/YES)
-
This setting will disable/enable the door overlap feature.
-
Used for a dual door operator, when there is a door overlap.
-
When enabled, the controls will communicate with one another, to create an overlap during the closing cycle.
-
Use the “UP” and “DOWN” buttons to disable or enable this feature
7.1.19 Factory reset (NO/YES)
-
This setting will restore the control unit to is original factory settings.
-
To reset
the control to the original setting, push the “UP” button, then push the “ENTER” button to confirm.
-
After pushing the “YES” button, the factory reset can be cancelled, by pushing the “MENU” or the “DOWN” buttons.
7.1.20 Display Light ON time (01-30)
-
This feature sets the length of time, in minutes, the display light will remain on, after the last button push of the control
unit.
-
This setting is an energy saving feature.
7.1.21 Software version MSW01 VX.XX
-
This menu will display the software version in the control unit, where X is a numeric value.
8.0 Wiring Connections
8.1 Selector Switch
3 position switch offers easy selection for 3 modes of operation.
1.
Hold Open
– The operator will hold the door, in the fully open position for an unlimited amount of time. The
motor will not overhead or fail causing the door to close.
2.
Manual
– The door is free to open by hand and will fully close with spring power. This function does not
switch off the power, however motion sensors / push plates are still active but are ignored.
3.
Automatic
– Motion sensors / push plates are active and will activate the operator to open the door
automatically should they be triggered.
