Smart Swing 3
®
Installation Manual
SMART SWING 3 ®
Page 13 of 36
Step 4.
Fixing Operator in Place
Be sure there is proper support
in the wall to secure the header
at the vertical jambs and behind
the header at intervals between
the vertical jambs.
A solid spacer material or filler may
be required to compensate for any
gap between the back of base rail
and wall.
Ensure, before fixing base rail to the
doorframe, that access holes for
power supply cables are in line, if
required
Secure the header box to the top of the door frame with the appropriate fasteners.
Holes can be made anywhere in header to secure. All holes MUST be drilled into substantial support
(studs, blocks, framing, etc.).
SPECIFY MIN QTY OF FIXINGS
TYPE OF FIXINGS & TYPE OF SCREWS
– FOR METAL BRICK AND WOOD.
SPECIFY CORRECT SPACING FOR FIXINGS
Step 5
. Once the header back plate is in place, install the motor/gearbox and control board to the header back
plate
Slide the nuts (supplied with the operator) to hold the motor/gear box and control board along the 2 parallel tracks
on the back plate.
Fasten the bolt to hold the motor/gear box and control board in place.
The motor/gearbox needs to be installed so that the center of
the spindle is 5 ¼” (133mm) from the end plate.
