Meyra 1.610, Maintenance And Service Manual

Page: 77 / 104

77
Seat inclination (camber), model 1.617
Replacing the adjustment motor for seat inclination
Drive the seat into the highest position in order to replace
the adjustment module (1) for seat inclination.
1. Pull the connection plug of the corresponding adjust-
ment motor (1) off of the adjustment module [2].
2. Remove the respective bolt (3) + (4) for attachment of
the adjustment motor for seat inclination.
☞
In doing so watch for cables that might still be attached.
– If required, remove corresponding cable binders.
3. Assembly of the adjustment motor is done analogue in
reverse order.
!
Attention:
It is to be observed that the cables are not damaged or
bent when being placed.
☞
Otherwise danger of fire through short circuits!
☞
Previously removed cable ties are to be replaced.
☞
Then carry out a function test.
☞
Therefore observe chapter Functional checks on
page 94.
1
3
4
2