Meyra 1.610, Maintenance And Service Manual

Page: 51 / 104

51
Carbon brushes
The carbon brushes (1) are supplied as a set and are to be
replaced as a set.
☞
Note:
☞
Do not touch the friction surface of the carbon brushes!
☞
The carbon brushes are worn when they are used up to
8 mm length.
They are also to be replaced when the contacts appear
black and dull. – On intact carbon brushes the contacts
are anthracite coloured and shining.
Removing the carbon brushes
Version 1:
1. Unscrew the locking cap (2) of the carbon brush coun-
ter-clockwise.
2. Pull the pressure spring with the carbon brush (1) out of
the guide shaft [3].
Version 2:
1. Slide the cap (4) of the carbon brush out towards the
back [5].
2. Pull the pressure spring with the carbon brush out of
the guide shaft [6].
Mounting the carbon brushes
Assembly of the carbon brush is done analogue in reverse
order to chapter
Removing the carbon brushes
on page 51.
☞
When mounting the carbon brush after a visual
check, observe that the carbon brush receives the
same position as when being removed.
1
2
4
3
5
6